| 空调移机步骤： |
| 添加时间：2020/11/26 16:25:45 浏览次数： |
| 空调移机步骤： Air conditioner moving steps: 一、准备工作 1、 Preparatory work 至少二人或二人以上熟练的制冷修理工，工具一套，安全带等安全设备。 At least two or more skilled refrigeration repairmen, a set of tools, safety belt and other safety equipment. 二、拆机的步骤 2、 Steps of dismantling machine 1．回收制冷剂 1. Recover refrigerant 无论是冬季，还是夏季移机，都必须把空调器中的制冷剂收集到室外机中去。拆机前应启动空凋器，可用遥控器设定制冷状态，待压缩机运转制冷状态正常后，用扳手拧下外机的液体管与气体管接口上的保帽，关闭高压管（细）的截止阀门，l分钟（大一点的空调就等2分 钟左右）后管外表结露，立即关闭低压管（粗）截止阀门，同的迅速关机，拔下电源插头，用扳手拧紧保险帽，至此回收制冷剂工作完成。（如果是冬季，宜先用温热的毛巾盖住室内机的温度传感器探头，然后控制冷状态设定开机。） Whether in winter or summer, the refrigerant in the air conditioner must be collected to the outdoor unit. Before dismantling the machine, the air conditioner should be started, and the refrigeration state can be set by the remote controller. After the compressor operates normally, the protective cap on the interface between the liquid pipe and the gas pipe of the external machine is unscrewed with a wrench, and the cut-off valve of the high-pressure pipe (fine) is closed. The air conditioner with a larger size is equal to 2 points for 1 minute Close the shut-off valve of the low-pressure pipe (thick) immediately, pull off the power plug and tighten the safety cap with a wrench, so as to recover the refrigerant. (in winter, cover the temperature sensor probe of the indoor unit with a warm towel, and then control the cold state setting to start the machine.) 2．拆室内机 2. Remove the indoor unit |
| 上一页 空调移机的操作要点。 |
| 下一页 空调移机注意事项 |
Copyright © 技术支持：遨游网络