天津市空调服务公司

Because of moving or some reasons, there will always be a problem of dismantling air conditioning. Maybe you can help with professional workers, but sometimes you can solve the problem yourself. So how to remove the air conditioning? Today Xiaobian finishing method on the open air conditioning for reference, attached air conditioning knowledge.

如何拆空调：

How to dismantle the air conditioner:

1、收氟。开机打制冷，压缩机工作后关闭高压阀运转一分钟，关闭低压阀，停机。拔掉电源插头(切记!!!!);

1. Fluorine collection. Turn off the compressor and turn off the high pressure valve for one minute, shut down the low pressure valve and stop. Unplug the power plug (remember!!!!!);

2、拆开室外机铜管接头(塑料布包好，防止进土)，拆开室外机电线接头(记住线的顺序);

2, outdoor machine brass fittings (plastic cloth, to prevent the soil), outdoor electrical connector (remember line order);

3、根据室内机的位置打出管的过墙眼儿，在预定位置钉好室内机的挂盘(必须保证水平，用水平仪校正)，将管穿出后挂好室内机;

3, according to the position of the indoor machine tube wall play: in a predetermined position hanging plate nail of the indoor machine (must ensure the level, the level of instrument calibration), the pipe is penetrated out after hanging indoor machine;

4、根据管的长度确定室外机的位置，室外机也要保证水平;

4, according to the length of the pipe to determine the location of the outdoor machine, the outdoor machine should also ensure the level;

5、接好高低压管，先打开高压阀，然后松低压管锁母(排出管路中的空气)，听到有出气的声音8～10秒后拧紧该锁母，打开低压阀，按顺序接好电线;

5, connect the high and low pressure pipe, first turn on the high pressure valve, then release the low pressure pipe lock (the air in the exhaust pipe), and hear the breath sound. After 8~10 seconds, tighten the lock mother, open the low pressure valve, and connect the wire in sequence.

6、接通电源，试机。用肥皂水检查管路接头(锁母处)有无泄漏。

6, connect the power supply, test machine. Use soapy water to check the leakage of the pipe joint (the lock mother).

拆空调注意事项

Precautions for dismantling air conditioning

旧空调的铜管韧性较差，容易挝成死弯;

Poor old brass toughness of air conditioning, easy to dance into the dead bent;

收氟和排空气要彻底;

To collect and exhaust the air thoroughly;

内外机要水平、牢固，否则噪音大;

The inside and outside machines are level and firm, otherwise the noise is big.

不能有泄漏。

There can be no leakage.

空调移机：

Air conditioning:

前期准备:工作人员上门拆机并带齐全套工具及安全设备.

Preparation: door staff with complete set of tools to disassemble and safety equipment.

回收制冷剂.首先开机制冷.外机运行后 收氟关闭小阀门，阀门结霜有化掉后关闭大阀门，立刻关机 拉掉电源，拧紧保险帽.使空调移机器中的制冷剂收集到室外机中去.

Recovery of refrigerant. The first boot machine running after cooling. Collecting fluorine to close small valves, valve is closed after frosting off valves, immediately shut down the power off, tighten the cap. The air conditioning refrigerant shift insurance in the machine to collect in the outdoor machine.

拆室内机. 拆卸室内机时，应防止冷凝水流进线路板;

When dismantling the indoor machine, the condensing flow should be prevented from entering the circuit board when the indoor machine is dismantled.

拆室外机. 拆卸室外机时 应卸放的同时注意平衡避免振动摇晃.最后用塑料包好以便搬运;

Dismantle the outdoor machine. When disassembling the outdoor machine, it should be unloaded while balancing the vibration to avoid shaking. Finally, it is packed with plastic for handling.

安装. 空调重新安装时应注意安装位置与对流. 最后，用洗涤剂进行检漏，观察每一个接头有无气泡冒出，验明系统确无泄漏后，旋紧阀门保险帽即可;

The new air conditioning installation. The installation should pay attention to the installation position and convection. Finally, leak with detergent, observe every joints without bubbles, verify the system without leakage, the valve cap can be tightened insurance;

检验. 最后排除管道和内机中的空气 开机试运行安装完成.

Finally, the test operation and installation of the air in the pipe and the inner machine are eliminated.