空调移机：

Air conditioning:

前期准备:工作人员上门拆机并带齐全套工具及安全设备.

Preparation: door staff with complete set of tools to disassemble and safety equipment.

回收制冷剂.首先开机制冷.外机运行后 收氟关闭小阀门，阀门结霜有化掉后关闭大阀门，立刻关机 拉掉电源，拧紧保险帽.使空调移机器中的制冷剂收集到室外机中去.

Reclaim refrigerant. First turn on the refrigeration. After the operation of the outside, the fluorine is closed to close the small valve. The frosting of the valve is turned off and the large valve is closed. The power supply is switched off immediately and the safety cap is tightened. The refrigerant in the air conditioning machine is collected in the outdoor machine.

拆室内机. 拆卸室内机时，应防止冷凝水流进线路板;

Indoor dismantling machine. When we remove indoor unit, we should prevent condensation water from entering the circuit board.

拆室外机. 拆卸室外机时 应卸放的同时注意平衡避免振动摇晃.最后用塑料包好以便搬运;

The outdoor unit should be dismantled. When the outdoor unit was disassembled, it should be unloaded and balanced at the same time, so as to avoid vibration and shake.

安装. 空调重新安装时应注意安装位置与对流. 最后，用洗涤剂进行检漏，观察每一个接头有无气泡冒出，验明系统确无泄漏后，旋紧阀门保险帽即可;

Installation. When the air conditioner is reinstalled, we should pay attention to the installation position and convection. Finally, use the detergent to leak detection, observe each joint has no bubbles, verify that the system does not leak, tighten the valve safety cap;

检验. 最后排除管道和内机中的空气 开机试运行安装完成.

Inspection. Finally, exclude the air in the pipeline and the internal machine, start the trial run and install it.